Configure WiFi on the iSMP4 pin pad terminal

By default, the iSMP4 pin pad terminals will come pre-configured to use Bluetooth as the communication method for an iPad running Revel POS.  If you need to have the iSMP4 connect to an iPad via WiFi instead, follow the steps below.

  1. From the main screen, press the "F" button four time and the unit will beep.
  2. Press the "F2" button for "Change Port".
  3. Use the "F2" or "F3" buttons to navigate to "WiFi" and then press the green button.
  4. Leave the option named "DHCP" to "Static".
  5. Press the "F3" button for "Change Settings".
  6. Select "Static" and then press the green button.
  7. Enter the appropriate IP address as 192.168.022.XXX and then press the green button.
  8. Enter the appropriate Subnet Mask as 255.255.255.0 and then press the green button.
  9. Enter the appropriate Gateway Address aka Default Gateway as 192.168.022.XXX and then press the green button.
  10. Enter the appropriate first DNS server as 008.008.008.008 and then press the green button.
  11. Enter the appropriate second DNS server as 008.008.004.004 and then press the green button.
  12. Select "Server" and then press the green button.
  13. Enter Port as 12000 and then press the green button.
  14. Set the SSL Mode to "Off" and then press the green button.
  15. Press the "F4" button for "Access Points".
  16. Press the "F4" button for "Add".
  17. Enter the appropriate SSID and then press the green button.
  18. Select "WPA/WPA2" and press the green button.
  19. Enter the password and then press the green button.
  20. Press the "F1" button to save the changes.
  21. The unit will now reboot and be connected to the appropriate wireless network.
Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk